Defective crankshaft bearings If the crankshaft bearings are defective, a slight backlash is observed on it. You can check for play by jogging the flywheel
Read more
Electric screwdriver battery where plus where minus
how to determine where the positive terminal is on the car and where is the negative one ? Negative terminal ?? ? o_O Actually, the
Read more
The battery of the electric screwdriver does not charge from the charger
What types of batteries are there? What types of batteries are used by screwdrivers? Nickel cadmium (NiCd). The first type of devices, holds a charge
Read more
How to cut the corner of a plastic ceiling plinth
Method Classic miter box The classic miter box is a U-shaped bed with slots in the opposite sides. A part of a suitable size is
Read moreHusqvarna 240 stalls when throttle is pressed
To the cold The reason why the device does not start on a cold one is often a violation of the engine start sequence. You
Read more
How to properly assemble the cutters on the cultivator
Care rules Forged steel is usually used in the manufacture, since it is stronger and more resistant to corrosion, but this does not exclude the
Read more
Stihl 180 stalls when you press the gas
Saw stops after gas release, Here you need to adjust the carburetor and check if there is a powerful air suction cup. The most common
Read more
How to properly cut skirting boards to the floor
Cutting the inner and outer corners of the skirting board All complex construction work eventually comes to an end and smoothly flows into the stage
Read more
How to properly cut porcelain stoneware with a manual tile cutter
Electric tile cutter If you have a large amount of work, then the fastest and highest quality cut comes from an electric tile cutter. They
Read more