Today for trimming grass or lawn in the garden often used a trimmer. The advantage of its use is the possibility of hedging a hedge, as well as the weed mowing, which has a thick stem.
The main working body of the trimmer is the spool. A line is wound on it, which, when the spool is rotated, cuts off almost everything that is on its way. It is for this reason that it is strictly forbidden to remove the plastic protective cover from the spool. The line that hits the leg can cut the muscles to the bone.
Principles of winding fishing line on the spool.
The fact is that, regardless of the trimmer, different fishing lines can be used.
The point is that there is a difference in the section of the fishing line. there is:
- round;
- square;
- triangular.
Which line is the most effective and durable? This is the topic of another article. Consider how you can wind the line on the spool and how much, in principle, it should be wound.
The fishing line sells in large hanks. On the reel can be 100 meters of fishing line. Naturally, even with active mowing, not only grass but also shrubs, such a supply is guaranteed to last for the whole season.
Plastic mowing head is the most common in terms of operation. Further instructions will be written for it.
Disassembly of the spool and winding fishing line.
It is necessary to remove the upper clamping cover to disassemble the mowing head. In most cases, it attaches to the base of the spool with a few clips.
It is necessary to act extremely carefully, as there are risks to break off the latches, especially if the plastic was in the cold for some time. After removing the presser cover, we pull out the spool, and with it the spring.
Thus, only the base of the spool should stay in our hands. It still sets aside. As a rule, a fishing line with a total length of 8 meters wounds onto a reel. It is necessary to accurately measure the segment mentioned above and fold it in half.
Next, it passes into the spool. Now you need to start winding the line in one direction. After the entire fishing line has been wound, it is necessary to make small sections of the fishing line look out from the spool on diametrically opposite sides.
Now it remains only to install a spring on the base, insert the spool, thread the above-described segments into special technological holes and close the entire structure with a pressure cap.