Replacing the bearing of the air conditioner compressor Nissan Almera n16 The original catalog picture does not show the thermostat cover gasket, but it must
Read moreReverse hammer with your own hands from a shock absorber
Materials and tools for manufacturing A quality backhoe can be made in the garage without the use of serious equipment and with minimal material costs.
Read moreHow to thread a water pipe
Threading. terms required This process is the machining of a rod or hole by means of a special tool for threading pipes in order to
Read moreHow to cut a brick at home
Careful cutting of bricks When masonry work is that a whole brick is not suitable, and the surfaces of chipped bricks are not sufficiently flat
Read moreWhy a single-axle tractor pulls to the side when plowing
Plowing with Neva power tiller (with plow) Technical progress and innovative technologies brought farmers a lot of modern equipment which not only helps to ease
Read moreHow to cut a hole in the tile for the socket
How to cut a round hole in a tile with an ordinary sandpaper Also, when repairing or tiling work, the choice of method depends on
Read moreWhy does a diesel single axle tractor go bad
When the engine goes into a spin, its speed increases sharply and the arrow on the tachometer moves into the red zone. Black clouds of
Read moreSTIHL ms 660 how to spot a fake
How to use a counterfeit If you for some reason became the owner of a Chinese STIHL 660, then do not immediately throw it away.
Read moreCutting tiles at a 45 degree angle
As a rule, under the corner cut tiles and tiles for wall or floor lining. Using the technique you can get an aesthetic framing without
Read more